Savin SPC210SF manual Remote commands, Retrieve a fax

Chapter 8

Remote commands

Follow the commands below to access features when you are away from the machine. When you call the machine and enter your Remote Access Code (3 digits followed by ), the system will give two short beeps and you must enter a remote command.

Remote commands		Operation details
95	Change the Fax Forwarding,
	Paging or Fax Storage settings
	1 OFF	You can select Off after you have retrieved or erased all your
		messages.
	2 Fax Forwarding	If you hear one long beep, the change has been accepted. If
		you hear three short beeps, you cannot change it because
	3 Paging
		something has not been set up (for example, perhaps a Fax
	4 Fax Forwarding number
		Forwarding or Paging number had not been registered). You
	6 Fax Storage	can register your Fax Forwarding number by entering 4. (See
		Changing the Fax Forwarding number on page 8-7.) Once you
		have registered the number, Fax Forwarding will work.
		You can select Off after you have retrieved or erased all your
		messages.
96	Retrieve a fax
	2 Retrieve all faxes	Enter the number of a remote fax machine to receive stored fax
		message(s). (See page 8-7.)
	3 Erase faxes from the memory	If you hear one long beep, fax messages have been erased
		from the memory.
97	Check the receiving status
	1 Fax	You can check whether your machine has received any faxes.
		If yes, you will hear one long beep. If no, you will hear three
		short beeps.
98	Change the Receive Mode
	1 External TAD	If you hear one long beep, your change has been accepted.
	2 Fax/Tel
	3 Fax Only
90	Exit	Press 9 0 to exit Remote Retrieval. Wait for the long beep, then
		replace the handset.

8 - 6