lWhenreplacingt heprojector lamp module:
oPutthe projector into Standby modeand wait 30 minutes for the lamp to cool
completely.
oDonot remove any screws other than those specified in the lampreplacement
instructions.
oWearprotective eyewear while changingthe lamp module.Failure to do so can cause
injuriesincludingloss of eyesight if the lamp shatters or bursts.
oUseonly replacement lamp modulesapprovedby S MARTīTechnologies.Contact your
authorizedSMART resellerfor replacement parts.
oNeverreplace the lampmodule with a previously used lamp module.
oAlways handlethe fragile lampass embly with care to preventprematurelamp failure or
exposureto mercury. Use gloves when touchingthe lamp module. Do not touch the
lampwith your fingers.
oRecycle ordispose of the lamp module as hazardouswaste in accordance with local
regulations.
Youneed a Phillips No. 2 screwdriver anda fl at screwdriverto c ompletethese procedures.
gTo removethe old lamp module
1. Pressthe Power button twice on the remotec ontrolor the ECP to put t heprojector into
Standbymode.
2. Waitat least 30minutes for the projector to cool down.
3. Disconnectthe power cable from the projector.
CH A P T E R 5
Maintainingyour interactivew hiteboard system
40