>set brightness-15
brightness=55
Video sourcespecification values
Youcan use the source input field describedin Source selection controls on next pagein a c ommand
toset anabsolute value or adjustmentv alueto a source other than the active source. You cando this
whilethe selected source is inactive, but the source device must be connected ory ouw ill receive an
invalidcommand response.
Seethe following examples, whereboth an HDMI connectorand a VGA 1 input arec onnected:
>set input=hdmi
input=hdmi
>set brightness vga1=65
brightness vga1=65
>set brightness vga1-7
brightness vga1=58
Powerstate controls
Thesecommands put the projectorin and out of Standby modeand request the projector’scurrent
powerstate. The projector’s powerst atedetermines whether certaincommands are availableat that
time.These settings are available evenw henthe projector is in Standby mode.
Command Response
on powerstate=[field]
off powerstate=[field]
offnow powerstate=[field]
getpowerstate powerstate=[field]
Thefollowing table describest hepower state commands:
Command Description
on Turnson the projector.
off Starts the shutdownprocess. A dialogbox appears with the
message,“Press Power Button to Turn off Projector.”Y oumust send
asecond Off commandwit hin10 seconds to put the projector into
Standbymode.
offnow Shuts downthe projector immediately. Youc an’t delayor cancel this
command.
getpowerstate Indicates the projector’s currentpower state.
AP P E N D I X B
Remotelymanaging your system throu gh an RS- 232 serial interface
75