Thesecommands informy ouof thec urrentsyst em settings. These commandsare available even
whenthe projectoris in Standby mode.
Command Response
getlamphrs lamphrs=[current lamp hoursof operation]
getsys hrs syshrs=[currentprojector hoursof operation]
getfwv erddp f wverddp=[currentprojectorfirmware version]
getfwv ernet fwvernet=[currentnetwork firmware version]
getfwv ermpu fwvermpu=[currentprocessorfirmware version]
getfwv erecp fwverecp=[current EC P firmware version]
getvgaoutnetenable vgaoutnetenable=[current]
getsignaldetected signaldetected=[trueorfalse]
getusb1source usb1source=[Videosource associated with the USB 1 connectoron
theECP]
getusb2source usb2source=[Videosource associated with the USB 2 connectoron
theECP]
Thesecommands controlt hec urrentsyst ems ettings. These commandsare unavailablewhen the
projectoris in Standby mode. SeeV alue-basedcommandmethods on page 74f ors ettingabsolute
andadjustment commands.
Command Command target range Response
setautosignal [target] =on
=off
autosignal=[target]
setlampreminder[t arget] =on
=off
lampreminder=[target]
sethighbrightness [target] =on
=off
highbrightness=[ target]
setautopoweroff [value] =0 to =240 autopoweroff=[value]
setz oom[ value] =0to=30 zoom=[value]
setprojectorid [value] =0 to =99 projectorid=[value]
sethposition [value] =0 to =100 hposition=[value]
setv position[ value] =-5to = 5 vposition=[value]
setaspectratio [target] =fill
=match
=16:9
aspectratio=[target]
setprojectionmode[ target] =front
=ceiling
=rear
=rearceiling
projectionmode=[target]
AP P E N D I X B
Remotelymanaging your system throu gh an RS- 232 serial interface
82