gTo put thenew lamp module into the projector
1. Removethe new lamp modulefrom its packaging.
2. Carefullyplace the lamp moduleinto the projector usingthe handle on thet opof themodule.
Holdthe lamp modulev ertically andguide it into its slot. Gently press the powerend of the
lampmodule againstthe projector to ensurethe power plug makes contact with the projector’s
powerreceptacle.
NN O T E
Youshould be ableto place the lamp module intot heprojector easily without applying much
force.
3. Usethe Phillips s crewdriverto secure the captive screws.
II M P OR T A N T
Donot over-tighten the screws.
4. Carefullyreplace thelamp cover.
5. Connectthe power cablet o the wall outlet.
6. Pressthe Power button onceon the remote control orEC P to confirm that the projectoris
operatingandthat the lamp moduleis correctly installed.
7. Putthe old lamp modulein a s ecurecontainer, andhandle it gently until you recycle it.
gTo finish theprojector lamp module installation
1. Turnon the projector.
2. Adjustthe projector imageif necessary(see Adjusting the image on page22).
3. Access the service menuto reset the lamp hours (see Resetting the lamphours on next page).
CH A P T E R 5
Maintainingyour interactivew hiteboard system
42