Thefollowing table describest hepower state fields:
Field Description
Powering Theprojectoris turningon.
On The projectoris on.
Cooling The projectoris c ooling.
Confirmoff Confirm off is a non-selectablepower state thatis returnedduring
stageone of the two-button Offsequence.
Idle Theprojectoris off but still receivingpower (Standby mode).
Sourceselectioncontrols
Thesecommands switch inputs ources.The sourcet ypedetermines whichc ommandscan be
accepted.
Command Response Available in Standby
mode
getinput input=[field] Yes
setinput=[field] input=[field] No
Thefollowing table describest hesource selection commands:
Command Description
getinput Returnsthe projector’s currentinput.
setinput=[field] Sets the inputto one of the selectable fields.
Thefollowing table describest hesource selection response fields:
Field Description
VGA1 Switc hes sourceto t heVGA 1 input connector.
VGA2 Switc hes sourceto t heVGA 2 input connector.
Composite Switchessource to the Composite video connector.
If you installedy ourinteractive whiteboards ystem accordingt o the
instructions,this is the relay from the ECP.
S-Video Switches sourceto t heS-Video input connector.
HDMI Switchessource to the HDMI input port.
None Anon-selectable valuethat appears when you entera “get input”
commandwhile the projectoris in Standbymode.
Generalsource controls
Thefollowing source controls applyto all input sources. HD MI connectors ourcecontrols are
describedin this section. These controls areunavailable when the projectoris in Standby mode. You
canspecify custom color values forall inputs.
Thesecommands informy ouof thec urrentsource settings.
AP P E N D I X B
Remotelymanaging your system throu gh an RS- 232 serial interface
76