Teac AG-15D owner manual Speaker Connections, How to connect, English

FRONT	FRONT
SPEAKER	SPEAKER

CENTER

SPEAKER

SUB￿

WOOFER

SURROUND	SURROUND
SPEAKER	SPEAKER

SUBWOOFER	SURROUND	SURROUND
	BACK	BACK
	SPEAKER	SPEAKER

Speaker Connections

Caution:

To avoid damaging the speakers with a sudden high-level signal, be sure to switch the power off before connecting the speakers.

Check the impedance of your speakers. Connect speaker with an impedance of 6 ohms or more.

The black speaker terminals are - (negative).

Generally, the + side of the speaker cable is marked to make it distinguishable from the - side of the cable. Connect this marked side to the + terminal and the unmarked side to the black - terminal.

Prepare the speaker cables for connection by stripping off approximately 10 mm or less of the outer insulation. (Removing too much insulation may lead to a short circuit if the bared wired should come in contact with each other.) Twist the strands of the stripped wires tightly together :

Caution:

The metal portions of the two separate wires should not touch or an electrical short can occur. Shorted wires can create a fire hazard or induce a failure in your equipment.

How to connect:

1.Turn the terminal cap counterclockwise to loosen it. The speaker terminal caps cannot be fully removed from the base.

2.Insert the wire into the terminal fully and turn the terminal cap clockwise to securely connect it:

Make sure none of the wire insulation is under the terminal, only the bare, stripped wire.

3. Make sure it is fastened firmly by pulling the cable lightly.

16 ENGLISH