1 |
| 3 |
| 2 |
| 4 |
1
2
3
4
82
Tuner 1
1Select TUNER by turning the FUNCTION knob (or press the TUNER button of the remote control unit).
Make sure the antennas have been connected (see page
2Select AM or FM by pressing the BAND button.
<If the BAND button is pressed while the source other than TUNER was selected, the source will be switched to TUNER automatically.
3Press the TUNING MODE button to select the tuning mode.
Each time the TUNING MODE button is pressed, the tuning mode changes as follows:
Automatic tuning mode
(“AUTO” indicator lights on the display.)
Manual tuning mode
(no indicator)
Preset tuning mode
(“PRESET” indicator lights.)
Select the Manual tuning mode or the Automatic tuning mode.
<When using the remote control unit, you can skip this step.
4Press the TUNING/PRESET button to tune in a station.
In the Automatic tuning mode, the unit starts searching for a station. When a station is tuned in, the tuning process will stop automatically.
If you want to stop the tuning process, press the TUNING MODE button.
In the Manual tuning mode, hold down the TUNING/PRESET button and release it when the station is tuned in.
When the TUNING/PRESET button is pressed momentarily, the frequency changes by a fixed step (FM: 50 kHz steps, AM: 9 kHz steps).
When using the remote control unit:
Hold down the TUNING button of the remote control unit for more than 0.5 seconds.
When a station is tuned in, the tuning process will stop automatically.
If you want to stop the tuning process, press the TUNING button.
When the TUNING button of the remote control unit is pressed momentarily (0.5 second or less), the frequency changes by a fixed step.
Press the TUNING button repeatedly until the station you want to listen to is found.
Repeat this step until the station you want to listen to is found.
<“TUNED” is displayed when a broadcast is correctly tuned in.
ENGLISH
