SOURce:SWEep Subsystem
AM700 Audio Measurement Set Programmer Manual 3–135
Query: SOURce[1–8]:SWEep:SPACing? returns LINEAR or LOGARITHMIC
for the spacing setting of the designated SOURce.
*RST: Sets spacing to LOGarithmic.
SOURce[1–8]:SWEep:TIME <numeric_value>
Usage: Sets the sweep time duration. This is interactive with dwell time as the dwell
per point adjusts to make the new sweep time.
Range: Sweep time <numeric_value> is from 1.00 to 1228800.00.
Units: Seconds
Query: SOURce[1–8]:SWEep:TIME? returns the sweep time in seconds.
*RST: Sets sweep time for 24.00 seconds.
SOURce[1–8]:SWEep:TIME:AUTO <Boolean>
Usage: Sets the sweep timing mode. If TIME:AUTO is ON, and a frequency sweep is
generated, the dwell time per point (and therefore the total sweep time) is
determined by the AM700 based on the current frequency and other factors. If
TIME:AUTO is OFF the parameters for SOUR:SWE:DWELL and
SOUR:SWE:TIME are used.
Query: SOURce[1–8]:SWEep:TIME:AUTO? returns 1 for ON, and 0 for OFF.
*RST: ON