Tektronix AM700 STATus:OPERation:TRIGger Registers

STATus:OPERation:TRIGger Registers
3–150 AM700 Audio Measurement Set Programmer Manual
STATus:OPERation:TRIGger Registers
The following status register commands for STATus:OPERation:TRIGger registers
follow the same format as the STAT:OPER registers.
Table 3–7: Trigger conditions used by the FFT application
Condition Definition Condition Number Summary bits
Awaiting Mtone on Ch 1 700 Set when waiting for a multi-
tone signal on the given
channel.
Goes to STAT:OPER:TRIG
bit 3.
Waiting Mtone on Ch 2 701 Goes to STAT:OPER:TRIG
bit 4.
Table 3–8: Trigger conditions used by the Scope application
Condition definition Condition number Summary bits
Triggered on Ch 1 750 Set when given scope
channel is triggered; cleared
while waiting for a trigger
Goes to STAT:OPER:TRIG
bit 5.
Triggered on Ch 2 751 Goes to STAT:OPER:TRIG
bit 6.