Preparing for a multipoint videoconference

Installing the MCU softwareNotes on installing the MCU software

•You cannot install the software if the write-protect tab on the Memory Stick in which the MCU software is stored is set to “LOCK”.

•Once the MCU software is installed in the Communication Terminal, the software will not be used again.

•You cannot install the MCU software which is copied to another Memory Stick with a computer, etc.

1 Set the power switch on the right side of the Communication Terminal to the off position (a).

2 Insert the “Memory Stick” containing the PCS-323M1 or PCS-320M1 MCU software into the Memory Stick slot.

Insert the “Memory Stick” in the direction of the arrow with the mark facing upward.

PCS-323M1 or PCS-320M1 MCU software

3 Set the power switch on the right side of the Communication Terminal to the on position (@).

The MCU software is installed in the Communication Terminal.

To check if the installation of the software is completed

The installed software will be shown in “Software Option” of the Machine Information menu.

For details on the Machine Information menu, see “Machine Information Menu” on page 50.

134 Preparing for a multipoint videoconference