Adjusting the Camera

You can adjust the image shot by the local camera that is sent to the remote party to obtain the desired angle and size.

During communication you can also control the camera on the remote site to adjust the image shot by the remote camera.

Selecting the Camera to be Controlled

Before adjustment, choose whether you control the local or remote camera.

1 Press the FAR/NEAR button on the Remote Commander.

The Display Control menu appears.

2 Press the B or b button on the Remote Commander to select “Control”, then switch between “Far” and “Near” with the V or v button.

Display Control

Display Control

FarNear

Camera

3 Press the PUSH ENTER button on the Remote Commander.

When “Far” is selected (the remote camera is selected), the FAR indicator is displayed.

When “Near” is selected (the local camera is selected), the FAR indicator does not appear.

Notes

•You cannot control the remote camera unless “Far End Camera Control” is set to “On” in the Dial Setup menu at a dialing party and the same item in the Answer Setup menu is set to “On” at an answering party.

•You cannot control the remote camera during a session if the remote control format of the remote camera is not H.281. If you cannot control the remote camera, ask the remote party about the remote control format of his camera.

•If the local and remote parties try to control the same camera at the same time, the camera may not operate correctly.

Videoconference Daily 3: Chapter

Adjusting the Camera 73