The FAR indicator is displayed on the monitor screen when the remote camera is selected.

5 Adjust the angle and zoom.

Use the V, v, B or b button to adjust the camera angle, and ZOOM button to adjust the zoom.

6 Press the PUSH ENTER button.

The setting is registered in the selected preset number.

Recalling the Preset Angle and Zoom Setting

You can move the camera to the preset position by recalling the preset camera angle and zoom with the monitor screen displayed while in communication. You can do the same with the launcher menu displayed while not in communication. Using the Camera menu also enables movement of the camera to the preset position.

To recall the preset setting in the monitor screen while in communication

1 Select the camera which you want to move to the preset position.

Press the FAR/NEAR button on the Remote Commander to open the Display Control menu, then select “Far” or “Near” under “Control”.

2 Press one of the number buttons 1–6 on the Remote Commander.

The setting of the selected preset number is recalled, and the camera moves to the preset position. The message “Load a camera angle saved to preset number 1 (-6)” appears.

To recall the preset setting in the launcher menu while not in communication

You can move the local camera to the preset position.

1 Select the screen in the launcher menu, then press the PUSH ENTER button.

2 Press one of the number buttons 1–6 on the Remote Commander.

The setting of the selected preset number is recalled, and the camera moves to the preset position. The message “Load a camera angle saved to preset number 1 (-6)” appears.

To recall the preset setting in the Camera menu

1 Display the Camera menu.

2 Use the V, v, B or b button on the Remote Commander to select “Preset Load”, then press the PUSH ENTER button.

Videoconference Daily 3: Chapter

Adjusting the Camera 79