Using the Display Control
During a multipoint videoconference with the MCU software installed in the communication Terminal you can control the following operations.
What is “Broadcast Mode”?You can use the “Split”, “Split (Fixed)”, “Voice Activate” and “Broadcast” modes.
Split modeThis mode allows display of the pictures from the connected remote terminals and the picture of the local terminal by splitting the monitor screen. According to the connected terminals,
Picture A | Picture B | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Picture on the local Picture C site
Picture A | Picture B | Picture C |
Picture D
Picture E
Picture on the local site
Notes
•When the
•If you switch the broadcast mode from Split mode to Voice Activate mode in which a picture of a specified terminal is shown in full screen during communication, the location of Pictures A to E will be changed when the Split mode is restored.
•When your system is in the Split or Split (Fixed) mode, you cannot control the camera on any connected remote terminals.
Using the Display Control 143
Videoconference Multipoint 7: Chapter