Notes
•After the power is turned on, the camera moves automatically for trial operation. Be careful not to catch your finger.
•If you use force to prevent the camera moving, it may not resume moving and not output a signal to the Communication Terminal. In this case, turn off the Terminal, and turn it on again.
•When you turn on the power of the Communication Terminal for the first time after installation, the setup wizard will appear after the
For setups using the wizard, see “Setting Up the System for the First Time
— Initial Setup Wizard” on page 28.
•Used with an optional device especially designed for use with this system, such as the Data Solution Box or ISDN Unit, for the first time, the Communication Terminal may automatically upgrade the software of the connected device. While the upgrading message is displayed on the monitor screen, be sure not to turn off the Communication Terminal. Doing so may cause malfunction of the system. System malfunction may also occur when a system
To save power the Communication Terminal will enter standby mode if you do not operate it for a specified period of time.
When the Communication Terminal is in standby mode, the POWER indicator lights in orange. Once the Communication Terminal receives a call, the standby mode is automatically released.
To release the standby modePress the @/1 button on the Remote Commander.
To specify the standby timeSpecify the time that you want the system to remain on before entering into standby mode (1 to 99 minutes) using “Standby Time” in the General Setup menu. If you do not want the system to enter the standby mode, set “Standby Mode” in the General Setup menu to “Off”.
For the “Standby Time” and “Standby Mode” settings, see “General Setup Menu” on page 44.
Notes
•The POWER indicator on the camera goes off when the system enters standby mode.
•If you use a Sony TV monitor with the IR repeater installed under the remote sensor, the TV monitor will enter standby mode together with the Communication Terminal.
24 Turning the System On/Off