Ending the Conference

1 Press the CONNECT/DISCONNECT ( / ) button on the Remote Commander.

The message “Disconnect?” appears on the monitor screen.

2 Press the B or b button on the Remote Commander to select “OK”, then press the PUSH ENTER button, or press the CONNECT/DISCONNECT ( / ) button on the Remote Commander.

The system is disconnected.

Note

The power of the Communication Terminal remains on even if the system is disconnected.

To cancel disconnection of the system

Select “Cancel” with the B or b button, then press the PUSH ENTER button.

To register the connected remote party in the Phone Book

You can easily register the remote party who has just disconnected.

If you set “Last Number Registration” in the General Setup menu to “On”, the message “Register this participant in the list?” appears after a conference with an unregistered remote party is finished. When you select “OK”, the Edit List menu appears.

Note

If the “Last Number Registration” is set to “Off”, the message does not appear.

For “Last Number Registration” setting, see “Last Number Registration” on page 44.

70 Receiving a Call from a Remote Party