6 F 3 B 0 3 6 2

Table 4.4 TermSTS (Part 2)

TermSTS

Status

 

 

03H

Parameter error

 

 

04H

Memory write protect

 

 

05H

(Reserved)

 

 

06H

Module error

 

Initialization in progress

 

Transmission complete

 

timeout

 

 

07H

No send channel (CH)

 

 

08H

Port address out of range

 

 

09H

Incorrect transmission word

 

count

 

 

0AH

Boundary error

 

 

0BH

Transmission error

 

 

0CH

No I/O response

 

 

0DH

(Reserved)

 

 

0EH

Send data capacity

 

exceeded

 

 

0FH

(Reserved)

 

 

Meaning

Occurs if a value other than 3 is specified for the module ID.

Occurs if a value other than 1 is specified for the channel number.

Occurs if a command number other than one of the following is specified for a SEND instruction.

000FH, 0011H - 0014H, 0018H, 0021H, 0031H, 0032H, 0034H, 0035H, 0037H, 0039H

Occurs if a command number other than one of the following is specified for a RECV instruction.

0015H, 0021H, 0033H, 0038H

Occurs if a value other than 1 to 8 is specified for the socket identifier. (See section 6.4 "Using the Ethernet Port Socket Interface".)

Occurs if an incorrect parameter is specified in a RAS information readout request.

(See section 7.6 "RAS Information Readout ".)

Occurs if an attempt to write is made when the remote registers were write protected.

Occurs if an attempt to read is made when the local registers were write protected.

Occurs if the Ethernet Port is down.

Occurs if the Ethernet Port is initializing.

Occurs if a T2N internal timer times out.

Requests: UDP open, UDP send, UDP close, TCP send, TCP close

Occurs if the corresponding Ethernet Port is not installed.

Occurs if the local port IP address was specified for the remote destination IP address.

Requests: Remote port loopback, register read/write

Occurs if either 0 words or 486 or more words were specified for either a register read/write or a remote port loopback request.

Occurs if either 0 words or 1001 or more words were specified for a UDC/TCP send/receive request.

Occurs if the specified area (start address + register range) does not exist in the T2N data storage registers.

Requests: RAS information readout, remote port loopback, UDP send/receive, TCP send/receive, register read/write

Occurs if the Ethernet Port returns an error response.

Detailed information (the Ethernet Port response status) is stored at B+1.

Occurs if the T2N cannot access the Ethernet Port.

Occurs if a request is discarded when a T2N internal resource insufficiency occurs due to increasing amounts of transfer data.

Occurs if a T2N retransmission times out.

36

Page 37
Image 37
Toshiba T2N instruction manual 0AH