6 F 3 B 0 3 6 2

4.If the Ethernet Port fails to enter run mode

This section assumes that the Ethernet Port has come up normally up to this point. Note that the parameters must be set up with a parameter setup request before issuing the operating mode control request used to switch the Ethernet Port from standby mode to run mode.

a.Parameter setup request

START

 

 

No

Is the parameter setup request

executed?

 

Yes

 

Does the SEND instruction

No

complete?

 

Yes

 

Check the status and resolve the

error.

Execute a parameter setup request that sets up the IP address and the message transmission

UDP port number.

Verify the status using the procedure described in the item 3 " If a SEND or RECV instruction fails

complete" on page 148.

END

To the operating mode control request flowchart

149

Page 150
Image 150
Toshiba T2N instruction manual 3 B 0 3 6 If the Ethernet Port fails to enter run mode, Parameter setup request