E6581160
4. Basic VF-S11 operations
The
Standard monitor mode : The standard inverter mode. This mode is enabled when inverter power goes on.
This mode is for monitoring the output frequency and setting the frequency designated value. In it is also displayed information about status alarms during running and trips.
•Setting frequency designated values ⇒ see 3.1.2
• Status alarm | 4 | |
If there is an error in the inverter, the alarm signal and the frequency will flash | ||
alternately in the LED display. |
| |
E: | When a current flows at or higher than the overcurrent stall level. |
|
R: | When a voltage is generated at or higher than the over voltage stall |
|
| level. |
|
N: | When a load reaches 50% or higher of the overload trip value. |
|
J: | When the temperature reaches the overheating protection alarm level. |
|
Setting monitor mode : The mode for setting inverter parameters.
|
| How to set parameters ⇒ see 4.2 | |
Status monitor mode | : The mode for monitoring all inverter status. | ||
| Allows monitoring of set frequencies, output current/voltage and terminal | ||
| information. |
|
|
|
| For more on how to use the monitor ⇒ see 5.1 | |
Pressing the key MODE will move the inverter through each of the modes. |
| ||
|
| Standard monitor |
|
| MODE | mode | MODE |
|
|
| |
Status monitor |
| Setting monitor | |
| mode |
| mode |
| MODE | |
Panel jog mode | : This mode allows you to jog the motor by controlling the | |
operation from the operation panel. | ||
|
This mode is hidden by default.
To use the panel jog mode, set the parameter H to.
27
