Toshiba VF-S11 manual 3.1.1How to start and stop

E6581160

3.1.1How to start and stop

[Example of a EOQF setting procedure]

	Key operated		LED display			Operation
				Displays the operation frequency (operation stopped).
				(When standard monitor display selection H=[Operation
				frequency])
				Displays the first basic parameter [History (CWJ)].
		MODE	CWJ
				Press either the	or	key to select “EOQF”.
3			EOQF
				Press ENTER key to display the parameter setting. (Default setting:).
				Change the parameter to  (terminal board) by pressing the			key.
			⇔EOQF	Press the ENTER key to save the changed parameter. EOQF and the
				parameter set value are displayed alternately.

(1) Start and stop using the operation panel keys (EOQF=)

Use the and keys on the operation panel to start and stop the motor.

: Motor starts. : Motor stops.

✩To switch between forward run and reverse run from the control panel, the parameter fr (forward/reverse run selection) needs to be set to 2 or 3.

(2)RUN/STOP by means of an external signal to the terminal board (EOQF=): Sink (Negative) logic

Use external signals to the inverter terminal board to start and stop the motor.

Short

Open

Ｆ

F

and

and

CC

CC

terminals: run forward		Slow down
	Frequency	and stop
terminals: slow down and stop	F-CC	ON
		OFF

(3) Coast stop

The standard default setting is for slowdown stop. To make a coast stop, assign a "1(ST)" terminal function to an idle terminal using the programmable terminal function.

Change to H=.

For coast stop, open the ST-CC when stopping the motor in the state described at left.The monitor on the

inverter at this time will display QHH.

Motor	Coast stop
speed
F-CC	ON
	OFF
ST-CC	ON
	OFF

20