Toshiba VF-S11 manual QHow to use the history function, E6581160

E6581160

QHow to use the history function

	Key operated			LED display			Operation
					Displays the operation frequency (operation stopped).
					(When standard monitor display selection H= [Operation
					frequency])
		MODE		CWJ	The first basic parameter “CWJ” (history function) is displayed.
				CEE	The parameter that was set or changed last is displayed.
					Press the ENTER key to display the set value.
					Press the	key and	key to change set value.
					Press the ENTER key to save the changed value. The parameter
4				⇔CEE
					name and the programmed value will flash on and off alternately.
				****	Use the same steps as those given above to display parameters that
					you want to search for or change setting with the			key and	key.
				JGCF	JGCF: First historic record
				(GPF)	GPF: Last historic record
		MODE		Parameter
				display	Press the MODE key to return to the parameter setting mode
				↓
					“CWJ.”
			MODE	CWJ
					After that you can press the MODE key to return to the status
				↓
					monitor mode or the standard monitor mode (display of operation
				HTH
			MODE		frequency).
				↓
				

Note) Parameter f700 (Prohibition of change of parameter settings) is not displaied in this “auh”.

4.2.5Parameters that cannot be changed while running

For safety reasons, the following parameters have been set up so that they cannot be reprogrammed while the inverter is running. Stop operation (“0.0” or “off” is displayed) before changing parameter settings.

[Basic parameters]

CW, CW, CW, EOQF*, HOQF*, V[R, HJ, XN, XNX, RV [Extended parameters]

H, H∼H, H∼H, H, H, H, H∼H, H,

H∼H, H, H∼H, H∼H, H, H, H, H,

H, H, H, H∼H

The setting of any parameter other than the above can be changed even during operation.

Keep in mind, however, that when the parameter H (prohibition of change of parameter settings) is set to  (prohibited), no parameters can be set or changed.

*Set H, cmod and fmod can be changed while the inverter is running.

34