E6581160
(Continued)
Item displayed | Key | LED | Communic | Description | |
operated | display | ation No. | |||
|
|
Note 8
Parts replacement alarm information
m }}}i
FE79
The ON/OFF status of each of the cooling fan, circuit board capacitor, main circuit capacitor of parts replacement alarm or cumulative operation time are displayed in bits.
ON:
OFF: _
m }}}i
Cumulative | Cooling fan |
operation time | Control circuit board capacitor |
| Main circuit capacitor |
5 |
| Note 9 |
|
|
Cumulative |
|
|
| V | FE14 | The cumulative operation time is displayed. |
operation time |
|
|
| (0.01=1 hour, 1.00=100 hours) | ||
|
|
|
|
| ||
|
|
|
|
|
|
|
Default display |
| MODE | QR |
| The cause of the trip is displayed. | |
mode |
|
| ||||
|
|
|
|
|
| |
Note 1: Items displayed can be changed by pressing 
or 
key in the each monitor mode.
Note 2: You can switch between % and A (ampere)/V (volt), using the parameter H (current/voltage unit selection).
Note 3: The input (DC) voltage displayed is 1 2 times as large as the rectified d.c. input voltage.
Note 4: The number of bars displayed varies depending on the setting of H (analog input/logic input function selection). The bar representing VIA or VIB is displayed only when the logic input function is assigned to the VIA or VIB terminal, respectively.
If H = 0: Neither the bar representing VIA nor the bar representing VIB is displayed.
If H = 1 or 2: The bar representing VIA is not displayed. The bar representing VIB is displayed.
If H = 3 or 4: Both the bar representing VIA and VIB are displayed.
Note 5: The number of bars displayed varies depending on the setting of H (logic output/pulse train output selection). The bar representing the
If H = 0: The bar representing
If H = 1: The bar representing
Note 6: The integrated amounts of input and output power will be reset to zero, if you press and hold down the 
key for 3 seconds or more when power is off or when the input terminal function CKWH (input
terminal function: 51) is turned on or displayed.
Note 7: Past trip records are displayed in the following sequence: 1 (latest trip record) ⇔2⇔3⇔4 (oldest trip record). If no trip occurred in the past, the message “PGTT” will be displayed. Details on past trip
record 1, 2, 3 or 4 can be displayed by pressing the 
key when past trip 1, 2, 3 or 4 is displayed. For more information, see 5.1.2.
Note 8: Parts replacement alarm is displayed based on the value calculated from the annual average ambient temperature, the ON time of the inverter, the operating time of the motor and the output current ( load factor) specified using H. Use this alarm as a guide only, since it is based on a rough estimation.
42
