Transition Networks
Appendix C: Device Commands & Descriptions Command Descriptions
arp Displays the arp cache.
clear counter Clears counters on all ports or on a specific port. Usage:
clearcounter [port=<portno>]
cls Clears the screen.
exit Exits the CLI/Telnet session.
factory defaults Resets the Device to factory default settings—all current
configurations will be erased.
help or ? Help or ?: Displays the available commands.
help <cmd >: Displays the command usage in detail.
ifconfig port=<portno> Used to configure port parameters. The port number for
the configured port must be specified. Valid port
numbers start at “1.”
Usage: ifconfig port=<portno>
[adminstate=<enable|disable]
[autoneg=<enable|disable>]
[duplex=<full|half>]
[speed=<10|100|1000>]
[portstring=<"value">(
max=64)
]
[iptraffic=<enable|disable>]
The configurable parameters are as follows:
adminstate: The port can be disabled or enabled.
autoneg: Enable/disable Auto-Negotiation on this
port.
duplex: When Auto-Negotiation is disabled,
Duplex Mode of the port can be set to
full/half duplex.
speed: The port speed can be set to 10/100 Mbps
when Auto-Negotiation is disabled.
portstring: A unique name can be assigned to each
port.
iptraffic: The IP traffic can be enabled/disabled on
each port individually.
Continued on next page
24-Hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600 122