Transition Networks Appendix C: Device Commands & Definitions
Command Description
set community Sets SNMP community name.
Usage: set community=<name>
set dhcp Enables/disables DHCP at boot time. In case DHCP
failed during initialization, retry using the “restart”
option.
Usage: set dhcp=<enable|disable|restart>
set downloadcfg Download the system configuration from a TFTP
Server.
Usage: Usage: set downloadcfg=<"filename">
[l3access=<enable|disable>] [ipsetting=<default|nochange>
Note: The ‘l3access’ and ‘ipsetting’ are options to turnOFF
IP access once the upgrade is done, and to change
the IP address, subnet and gateway to factory
defaults.
set forceupg Enable/disable forcing a firmware upgrade of the peer
on specified port, automatically.
Usage: set forceupg port=<portno>
set gateway Sets gateway address.
Usage: set gateway=nn.nn.nn.nn
set groupstring Sets group string for the system.
Usage: set groupstring=<"name">
(max=64)
set uploadcfg Sets uploading the system configuration to a TFTP
Server.
Usage: Usage: set uploadcfg=<"filename">
set downloadcfg Sets Downloading the system configuration from a
TFTP Server.
Usage: Usage: set
set ip Sets IP address.
Usage: set ip=nn.nn.nn.nn
set l3capability Enables/disables all layer-3 traffic.
Usage: set l3capability=<enable|disable>
set mgmtvlan Sets management VLAN ID for management traffic.
Usage: set mgmtvlan=<vlanid>
set niecho Sets the number of echo frames to be sent, and start the
non-intrusive echo frame generation on the interface.
Usage: set niecho port=<portno> count=<1-100>
set autoupg Enable/disable auto upgrade. When enabled, Auto
firmware upgrade be done.
Usage: set autoupg=<enable|disable>
set forceupg Enable/disable Forcing Auto firmware upgrade on Peer
on specified port
Usage: set forceupg port=<portno>
Continued on next page
124 24-Hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600