Section IV: FBRM/BFFG Initial Device Setup Transition Networks
Initial Device setup via USB CLI, continued DHCP method To set the IP configuration via the DHCP in console mode, do the following:
Note: A DHCP server must be on the network and accessible before using this
method.
Step Action
1. At the console> prompt type set dhcp=enable
2. Press the ENTER key and the screen will appear as shown in Figure 31.
Figure 31: Enable DHCP
3. Type reboot
4. Press the ENTER key to reboot the Device and start the DHCP process.
Note: DHCP “successful” will appear on the screen when completed, or “failed” if
not successful.
Continued on next page
36