Appendix D: IP-Based and Chassis Management Parameters Transition Networks
Table 28: Port Configuration Parameters (continued)
Parameter IP based Chassis Description
9
Discard Tagged When enabled, all non-management
frames processed as tagged are discarded.
If double tagging is enabled, then this
check is performed after Ingress double
tag removal. Frames with priority and
VLAN of “0” are considered tagged.
9
Discard Untagged When enabled, all non-management
frames processed as untagged are
discarded. If double tagging is enabled,
then this check is performed after Ingress
double tag removal. Frames with priority
and VLAN of “0” are considered tagged.
9
Discard Untagged When enabled, all non-management
frames processed as untagged are
discarded. If double tagging is enabled,
then this check is performed after
‘ingress’ double tag removal. Frames
with priority and VLAN of “0” are
considered tagged.
9
Double Tagging This enables ‘ingress’ double-tagging. It
is a way to isolate one VLAN from
another VLAN hierarchically. When
enabled, also enables ‘egress’ double
tagging. In this mode, the Ingress port
removes the first IEEE 802.3ac tag that
appears after the source address. If a
frame is untagged, it is not modified. If it
is single tagged it is removed; if it is
double tagged, the first tag is removed.
9 9 The Duplex Modeof the port (half/full). Duplex
9
Egress Monitor
Port When enabled, all ‘egress’ frames that
come from this port are sent to the
‘egress’ monitor destination port
(sfbrm100SwEgressMonPort).
Continued on next page
24-Hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600 133