Transition Networks Appendix D: IP-Based and Chassis Management Parameters
Table 28: Port Configuration Parameters (continued)
Parameter IP based Chassis Description
9 9
Pri3 Ingress Rate
Control Rate limit for Priority “3” frames to be
the same or twice that of the Priority “2”
frames.
9 9
Remote Loopback Enable/disable OAM loopback on the
remote.
9 9
Reset Port
Counters Resets the port counters.
9
SA Priority
Override When enabled, the source address of the
frame is checked against the address
database entry with the matching source
address with priority override enabled.
When there is a match, the fame priority
is the one found in the entry. The source
address priority override has a higher
priority than the default frame priority, IP
TC, IEEE priorities, and the VLAN
priority override values. Normal frame
priority processing occurs when disabled.
9 9
Speed The speed in Mbps for this interface. It is
the resolved speed when Auto-
Negotiation is enabled or the manually
set the value when Auto-Negotiation is
disabled.
9
Use Both Traffic
class When a frame has an IEEE 802.ac tag
and an IP TOS, then this depends on
which priority is chosen, IP TOS or IEEE
tag when both sfbrm100PortUseIPTC and
sfbrm100PortUseTagTC are enabled.
9
Use IP Traffic
class This enables the IP Traffic class priority
if present. If disabled, the TOS bits are
ignored.
9
Use Tag Traffic
class This enables the IEEE 802.1p priority if
the frame is IEEE 802.3ac tagged, or else
it is ignored even if the tag is present.
Continued on next page
138 24-Hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600