Appendix D: IP-Based and Chassis Management Parameters Transition Networks
Table 28: Port Configuration Parameters (continued)
Parameter IP based Chassis Description
9
Forward Unknown When enabled, unicast frames with
unknown destination addresses are
allowed to ‘egress’ this port if VLAN is
enabled. The VLAN setting also allows
this port to ‘egress.’
9 The priority remapping for frames that
‘ingress’ this port. The IEEE tagged
frames with priority ‘n’ get this new
remapped priority inside the switch; also
if it egresses this port as tagged, the
priority is set in the tag.
IEEE Priority class
‘n’ [0-7]
9
IGMP Snoop This enables IGMP frame forwarding to
the CPU. IGMP is not supported in the
present release.
9 9
Ignore Loopback This corresponds to the EFM OAM MIB.
It decides whether the OAM loopback on
this port should be ignored.
9
Ignore Wrong Data This is related to the Port Lock. Enabling
this parameter will stop source-address
violations caused by Port Lock.
9 9
Ingress Limit mode This determines what kinds of frames are
limited and counted against ‘ingress’
limiting. Frames not limited by this
setting are not counted against the limit.
9 When enabled, all ‘ingress’ frames are
sent to the ‘ingress’ monitor destination
port (sfbrm100SwIngressMonPort).
Ingress Monitor
Port
9
IP Traffic When disabled, all IP traffic through this
port to the CPU is restricted.
9 Speed and duplex capabilities of the Link
Partner.
Link Partner
Autoneg ability
9
Link Partner Pause
ability Pause frame capabilities of the Link
Partner.
9 9
Link Status The link status of the port.
Continued on next page
24-Hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600 135