Section IV: FBRM/BFFG Initial Device Setup Transition Networks
Initial Device setup via telnet (directly to Device) To set up the Device initially via telnet directly to the Device, do the following:
Initial setup via
Telnet to
Device Step Action
1. At the command line type: Telnet nnn.nnn.nnn.nnn (IP address of the Device) to
bring up the password prompt, shown in Figure 33.
Figure 33: Password Prompt
Type the case-sensitive username and password (default is ‘root’ for
both).
2.
3. Press the ENTER key to launch the console prompt, shown in Figure 34.
Figure 34: Console Prompt
Continued on next page
38