Section Vll: FBRM/BFFG Operation Transition Networks
Firmware upgrades, continued
The Device can be upgraded remotely using TFTP. A valid IP address, subnet,
gateway, TFTP server IP address, and filename must be configured before starting
the upgrade process.
TFTP method
TFTP can be started in the following ways:
• ‘tftpupgrade’ command at the CLI
• On the web using Æ “Local System Configuration” Æ ‘TFTP upgrade’
[perform(1)]
• Using SNMP, set ‘sfbrm100SysTFTPCmd’ to ‘1’ (perform)
After initiating the command, the system resets to start the bootloader, and then the
tftp upgrade will start. A message will appear like the example shown Figure 64.
Figure 64: Firmware Upgrade via TFTP
After a successful upgrade, the application will start up.
Continued on next page
10/100BaseT to 100BaseFX IPBased 802.3ah Bridge
Version A
Copyright (c) 2006 Transition Networks
Reading config from flash........done
Erasing Application Memory
Set to TFTP Boot from Server nnn.nnn.nnn.nnn
Getting File : FBRM.bin . . . . . . . . . . . done
Checking CRC. . . . . . . .
78 24-Hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600