Section Vll: FBRM/BFFG Operation Transition Networks
Firmware upgrades, continued
Accessing the
bootloader CLI To access the bootloader CLI to upgrade the firmware, do the following:
Step Action
1. When “Transfer Failed” appears on the screen, within ‘2’
seconds, press the CTRL-C keys to bring up the bootloader CLI, as
shown in Figure 65.
Figure 65: Bootloader CLI
2. At the BOOT:> prompt type the letter “h” to bring up the help screen,
shown in Figure 66.
Figure 66: Bootloader Help Screen
Note: When you press the LETTER key of any command it might not appear at
the BOOT:> prompt, but the result will appear on the screen.
Continued on next page
10/100BaseT to 100BaseFX IP-Based 802.3ah Bridge
Version A [Mar 2 2006 09:56:02]
Copyright (c) 2006 Transition Networks
Reading config from flash........done.
BOOT LOADER CLI
Type 'h' for help
BOOT:>
h Display this help
p Ping a host
z Clear entire Application flash
x Set boot method as xmodem
t Set boot method as tftp
o Set boot method as OAM
s Show system information
n configure network information
r reset system
q Exit Boot CLI
BOOT:>
80 24-Hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600