Appendix C: Device Commands & Definitions Transition Networks
Command Description
set slpt Enable/disable Selective Link pass through.
Usage: set slpt=<enable|disable>
set tlpt Enable/disable Transparent Link pass through.
Usage: set tlpt=<enable|disable>
set 12cp Sets the L2CP protocol diposition per port if 'port' is
given, else sets all ports forwarding rule for that
protocol.
Usage: set l2cp="<stp|slow|dot1x|elmi|lldp|bmgmt|garp|other>"
port=<portno> act="<forward|discard>"
set fiberredund Sets Enable/disable Fiber Redundancy.
Usage: set fiberredund=<enable|disable>
Set fiberrevert Enable/disable Fiber Redundancy revert.
Usage: set fiberrevert=<enable|disable>
set netmask Sets subnet mask.
Usage: set netmask=nn.nn.nn.nn
set orceupg Enable/disable forcing auto firmware upgrade on the
peer of a specified port.
Usage: set forceupg port=<portno>
set password Sets password for CLI access through serial port/telnet.
This is used when RADIUS is disabled.
Usage: set password=<"value">
(max=64)
set radius Enables/disables RADIUS authentication. RADIUS is
disabled by default.
Usage: set radius=<enable|disable>
set radiusip Sets RADIUS server IP.
Usage: set radiusip=nn.nn.nn.nn
set radiussecret Sets RADIUS secret shared with the RADIUS server.
Usage: set radiussecret=<"value">(max=64)
set snmpaccess Enables/disables all SNMP access.
Usage: set snmpaccess=<enable|disable>
set tftpfile Sets tftp filename to be downloaded using upgrade with
TFTP.
Usage: set tftpfile=<"value">(max=64)
set tftpserver Sets TFTP server IP address to be used for upgrading
via TFTP.
Usage: set tftpserver=nn.nn.nn.nn
set trapmgr Sets trap manager address.
Usage: set trapmgr nn.nn.nn.nn
set uploadcfg Uploads the system configuration to a TFTP Server.
Usage: set uploadcfg=<"filename">
set usb Disables the USB port. This disables access through the
USB port. It can be enabled using IP-based or Point
System management.
Usage: set usb=disable
Continued on next page
24-Hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600 125