Section V: FBRM/BFFG Device Management Transition Networks
Device management via IP web-base (directly to Device), continued OAM
configuration The OAM co nfiguration screen allows enabling or disabling OAM by setting the
mode to “active” or “passive.” If the remote Device is a Transition Networks
FBRM/BFFG Device, the main menu (PORT button with the remote Device
connected) will show the options for managing the remote OAM peer.
The Devices are interoperable with other IEEE 802.3ah compliant Devices. Standard
OAM discovery, loopback, dying gasp, link and other critical events are supported.
The OAM configuration screen for that port will show the following:
• OAM state
• MAC address
• OUI (unique identifier)
Note: On the SFBRM1040-1xx redundant models, there can be only one (1) OAM
session at a time—the OAM enabled port is user selected. Port 2 fiber is the
default port.
OAM config
screen To view the OAM configuration screen for non-transition networks IEEE 802.3ah
compliant Devices, do the following:
Step Action
1. Click any port VIEW button on the CFBRM/CBFFG main menu to bring
up configure screen of that port.
2. Click the OAM Config button and the screen will appear, as shown in
Figure 58.
3. You can set up OAM parameters on this screen.
Figure 58: OAM Configuration and Status Screen (OAM Config Button)
58 24-Hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600