Transition Networks Appendix C: Device Commands & Definitions
Command Description
set username Sets username for CLI access through serial port/telnet.
This username is used when RADIUS is disabled.
Usage: set username=<"value">
(max=64)
show Displays all the current configurations at the system
level, including installed firmware revisions, network
configurations, system uptime, etc.
show version Shows current version of the firmware build
information.
Show redundancy Shows fiber redundancy settings.
show ifcabletest Performs cable tests and displays the cable status for all
or a specified port.
Usage: show ifcabletest port=<all | port no>
show ifconfig Displays port configurations, including speed, duplex,
and IP access for a specified port, or all ports.
Usage: show ifconfig [port=<all | port no>]
show ifoam Displays OAM configuration and status for all or a
specified port.
Usage: show ifoam [port=<all | port no>]
show ifrmonstats Displays RMON statistics for all or a specified port.
Usage: show ifrmonstats [port=<all | port no>]
show ifstats Displays port statistics for all or a specified port.
Usage: show ifstats [port=<all | port no>]
show oamloopback Displays OAM Loopback status for all or a specified
port.
Usage: show oamloopback [port=<all | port no>]
show niecho Displays Non-intrusive echo generation status for all or
specified port
Usage: show niecho [port=<all | port no>]
show 12cp is (L2cp) Displays L2CP disposition for all or specified port
Usage: show l2cp [port=<all | port no>]
show oampeer Displays OAM peer information for all or a specified
port.
Usage: show oamloopback [port=<all | port no>]
show oamstatistics Displays OAM PDU statistics for all or a specified port.
Usage: show oamstatistics [port=<all | port no>]
Continued on next page
126 24-Hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600