Transition Networks Section ll: FBRM/BFFG Hardware Installation
Installing fiber and copper cables, continued Caution Copper based media ports, e.g., Twisted Pair (TP) Ethernet, USB, RS232,
RS422, RS485, DS1, DS3, Video Coax, etc. are intended to be connected to
intra-building (inside building) link segments that are not subject to lightening
transients or power faults. Failure to observe this caution could result in
damage to equipment.
Copper cable To install the copper cable, do the following:
Step Action
1. Locate a 10/100 or 10/100/1000Base-T compliant copper cable with
male, RJ-45 connectors installed at both ends.
2. Connect the RJ-45 connector at one end of the cable to the Device’s RJ-
45 ports.
3. Connect the RJ-45 connector at the other end of the cable to the 10/100
or 10/100/1000Base-T RJ-45 port on the other Device (switch,
workstation, etc.). See Figure 15.
Figure 15: Copper Cable Installation
24-Hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600 21