TRENDnet BRV204 manual Data LAN Screen, Buttons

TW100-BRV204 User’s Guide

LAN Screen

Use the LAN link on the main menu to reach the LAN screen An example screen is shown below.

Figure 7: LAN Screen

Data - LAN Screen

TCP/IP
IP Address	IP address for the TW100-BRV204 , as seen from the local LAN. Use
	the default value unless the address is already in use or your LAN is
	using a different IP address range. In the latter case, enter an unused IP
	Address from within the range used by your LAN.

Subnet Mask

DHCP Server

Buttons

Save

Cancel

The default value 255.255.255.0 is standard for small (class "C") networks. For other networks, use the Subnet Mask for the LAN segment to which the TW100-BRV204 is attached (the same value as the PCs on that LAN segment).

•If Enabled, the TW100-BRV204 will allocate IP Addresses to PCs (DHCP clients) on your LAN when they start up. The default (and recommended) value is Enabled.

•If you are already using a DHCP Server, this setting must be Disabled, and the existing DHCP server must be re-configured to treat the TW100-BRV204 as the default Gateway. See the follow- ing section for further details.

•The Start IP Address and Finish IP Address fields set the values used by the DHCP server when allocating IP Addresses to DHCP clients. This range also determines the number of DHCP clients supported.

See the following section for further details on using DHCP.

Save the data on screen.

The "Cancel" button will discard any data you have entered and reload the file from the TW100-BRV204 .

16