Restoring Factory Default Settings
Press and hold the Power button down for 6 seconds to reset the camera to the factory defaults. You will see “300” displayed in the IP Address LCD display to indicate that the camera has been reset. Release the Power button to reset the camera.
Appendix
A
Note: You will need to reconfigure your camera settings after resetting the camera. The Veo Observer will revert back to the factory default username (admin) and password (password) if the camera is reset. The network settings on your camera will also revert back to DHCP, thus, you may need to reconfigure the camera using the Observer Setup Utility. Refer to Chapter 5: Observer Setup Utility for directions on configuring the camera’s settings.
Page 43 of 65
