Camera Setup

Before installing the Veo Observer Camera, you should have an available Ethernet LAN connection (RJ-45 port). To view the camera’s image or make any manual configuration changes, you will need a Windows PC with Internet Explorer 5.0 or higher, also connected to the LAN.

2.1 Hardware Setup

Connecting the Ethernet cable

Chapter

2

Step 1. Plug the included Ethernet cable into the RJ- 45 connector at the back of the camera as shown.

Step 2. Plug the other end of the Ethernet cable into any available LAN port. A typical home router/gateway connection is shown on the left.

Connecting the power adapter

Step 3. Connect the power supply to the back of the camera as shown, and then plug the supply into an available power outlet.

CAUTION: Make sure to only use the power adapter supplied with your Veo Observer Network Camera. Using a non-approved power adapter may damage the camera.

Page 7 of 65

Page 7
Image 7
Veo Observer manual Camera Setup, Hardware Setup, Connecting the Ethernet cable, Connecting the power adapter