Vidikron VP-60, VP-42HD, VP-50 ID Number Setting, To set the ID Number to O2, ID Number settings

ID Number Setting

When using more than one of these displays, this function sets ID numbers so that operation of the remote control does not cause multiple monitors to operate at the same time.

Example: Setting “2”

Perform the following operations.

Press the MENU button on the remote control to display the MAIN MENU on the screen, then...

1.Use the and buttons to select “SETTING 3”, then press the MENU button. The “SETTING 3” screen appears.

2.Use the and buttons to select “ID NUMBER”.

3.To set the ID NUMBER to “O2”...

Use the and buttons to select “2”.

The mode switches as follows each time the and button is pressed:

ALL	1	2		....	255	256
	SETTING 3				3 / 3
	PREVIOUS PG.
	TIMER
	INPUT SELECT		: LAST
	CONTROL LOCK :			ON
	IR ENABLE		:	OFF
	LOOP OUT		:	OFF
	ID NUMBER		:	2
	VIDEO WALL
	SEL.		ADJ.		EXIT EXIT

OSD (On Screen Display) Controls

*To reset back to ALL Press the CLEAR button.

Information

■ID NUMBER settings

ALL	ID NUMBER will not be set.
1 to 256	ID NUMBER will be set.

■When the ID NUMBER has been set

You can also set ID NUMBER for each remote control to operate the plasma display individually. To do so, requires special remote control available only from Vidikron factory Service Department.

■Restoring the factory default settings

Select “FACTORY” under the SETTING 1 menu.

Note that this also restores other settings to the factory defaults.

To set the ID number for the remote control (requires special remote control available only from Vidikron factory Service

Department)

Example: Setting “2”

1.Use the and buttons to select “ID NUMBER”.

2.To set the ID NUMBER to “2” ...

Use the and buttons to select “2”. The mode switches as follows each time the and button is pressed:

ALL 1 2 .... 255 256

67