Vidikron VP-60, VP-42HD, VP-50 owner manual Troubleshooting, 110

Troubleshooting (continued)

SYMPTOM

CHECKS

REMEDY

Poor picture with RGB signal input.	• Improper control setting. Incorrect 15 PIN connector pin	• Adjust picture controls as needed. Check pin assignments and
	connections.	connections.
Tint is poor or colors are weak.	• Are the tint and colors properly adjusted?	• Adjust the tint and color (under PICTURE).
Nothing appears on screen.	• Is the computer’s power turned on?	• Turn on the computer’s power.
	• Is a source connected?	• Connect source to the monitor.
	• Is the Auto Off function in the standby or off mode?	• Operate the computer (move the mouse, etc.)
	• Is LOOP OUT set to ON?	• Set LOOP OUT OFF.
Part of picture is cut off or picture is not	• Is the position adjustment appropriate?	• Adjust the IMAGE OPTIONS properly.
centered.
Image is too large or too small.	• Is the screen size adjustment appropriate?	• Press the ASPECT button on the remote control and adjust
		properly.
Picture is unstable.	• Is the computer’s resolution setting appropriate?	• Set to the proper resolution.
POWER/STANDBY indicator is lighted	• Horizontal and / or vertical sync signal is not present when the	• Check the input signal.
in red.	Auto Off control is on.
POWER/STANDBY indicator is blinking	• The temperature inside the main unit has become too high and has	• Promptly switch off the power of the main unit and wait until the
in red.	activated the monitor.	internal temperature drops. See *1.
POWER/STANDBY indicator is blinking	----------	• Promptly switch off the power of the main unit. See *2.
in green and red, or green.

*1 Overheat Protector

If the monitor becomes too hot, the overheat protector will be activated and the monitor will be turned off. If this happens, turn off the power to the monitor and unplug the power cord. If the room where the monitor is installed is particularly hot, move the monitor to a cooler location and wait for the monitor to cool for 60 minutes. If the problem persists, contact your Vidikron Authorized Dealer.

*2 In the following case, power off the monitor immediately and contact your Vidikron Authorized Dealer or Vidikron Authorized Service Center. The monitor turns off 5 seconds after powering on and then the POWER/STANDBY indicator blinks. It indicates that the power supply circuit, plasma display panel or temperature sensor have been damaged.

110