Whirlpool 4322616 manual Dryer Access, Control Panel Access

5.Lift and pull the washer assembly forward out of the cabinet. From this position it is possible to service all the washer components, which are similar to those used in other Whirlpool direct drive washers.

6.When reinstalling the washer mechanism, it is important to insure that the base restraints are properly positioned and that the wiring harness, drain hose, vacuum break, and pressure hose are properly installed and positioned.

Dryer Access

!WARNING

Electrical Shock Hazard

Disconnect electric power from appliance before servicing.

Replace all panels before operating.

Failure to do so could result in death or electrical shock.

Control Panel Access

1.Remove the three (3) screws that hold the Control Panel in place. (Fig. 5-22)

2.Remove the transition panel by removing the three (3) retaining screws. (Fig. 5-22)The wiring diagram is located on the back side of the transition panel

3.Lift the console up and flip it forward, being careful not to damage the knobs or the dryer front panel. (Fig. 5-23)

Fig. 5-23

Screws

Front

Panel

			Toe
		Panel
		Transition
			Panel
Retaining
	Screws
	Fig. 5-22
			Dryer
Start
Switch			Timer

Water

Level

Switch

Washer

Timer

Water

Temperature

Switch

113