Xantrex Technology XTR 850 WATT SERIES Enabling the Output, Shipped Configuration Local Operation

Enabling the Output

Shipped Configuration (Local Operation)

The power supply is configured for local operation at the factory. See Table 3-3 for a summary of this configuration. For more information on default settings, see Table 3-9 on page 3–39.

Table 3-3Shipped Configuration

Local Control Configuration	Additional References
Use the front panel controls to	See Chapter 3, “Local Operation” for front
adjust the output voltage and	panel operation. See Chapter 4, “Analog
current set point settings.	Programming (APG) and Isolated Analog
	Programming (ISOL)” for analog
	programming procedures.
The OVP set point is adjusted at	See “Using Over Voltage Protection	3
the front panel to 105% above the	(OVP)” on page 3–25 for the adjustment
maximum rated output voltage.	procedure.

Enabling the Output

Quick Tip Remote Operation uses these commands. See page 5–1.

Enabling the output on will also turn off the ALARM LED if the ALARM LED has been latched on due to an alarm triggering and automatically clearing. See “Alarms and Errors” on page 3–18.

To enable the output power:

◆Press the OUTPUT ENABLE Main button on the front panel or enter the SCPI command.

The OUTPUT ENABLE Main button will illuminate.

To disable the output power:

◆Press the OUTPUT ENABLE Main button when the OUTPUT ENABLE Main button is illuminated.

The output will be disabled and the LEDs will not be illuminated.

Important: The main output will not turn on if the shutdown function is activated. See “Using the External Shutdown Function” on page 3–30.

The SCPI command (s) for these instructions are:

[:]OUTPut[<channel>][:POWer][:STATe]

M370046-01 3-15