•When the LIGHT switch is set to MANUAL and the switch of the light is set to ON, the light is always on.

 

7 Push the MENU knob.

3

The ? mark at the left of setting changes to a z mark and the z

mark at the left of PRE-LIGHTING changes to a t mark.

8 To end the menu operation, set the MENU ON/OFF switch to OFF or close the cover of the menu operating section.

The menu disappears from the viewfinder screen and the message “INTERVAL *SEC *FRAME”, indicating the continuous trigger mode of the Manual Interval Rec mode, appears along the bottom of the viewfinder.

*SEC indicates the trigger interval preset and *FRAME indicates the number of frames preset.

The display indicating the current status of the camcorder appears along the top and bottom of the viewfinder.

Note

The settings for the continuos trigger mode of the Manual Interval Rec mode are maintained until changed. However, if you switch the camcorder power off, Manual Interval Rec mode settings are cleared except for the NUMBER OF FRAME, TRIGGER INTERVAL, and PRE-LIGHTING settings. To use the continuous trigger mode of the Manual Interval Rec function again after switching on the power, perform steps 1 to 2 in “Setting the single trigger mode” on page 3-40.

3-48Chapter 3 Recording and Playback