However, the tape may run to record the picture data stored in the memory before stopping the manual interval recording.
• Menu operation
In the single trigger mode of the Manual Interval Rec mode, you cannot change the settings of LOOP/INTVAL REC and NUMBER OF FRAME
on the FUNCTION 1 page after the camcorder starts recording. To 3 change the settings, stop the recording pressing the EJECT button or
setting the POWER switch to OFF.
In the continuous trigger mode the Manual Interval Rec mode, you cannot change the settings of LOOP/INTVAL REC, NUMBER OF FRAME and TRIGGER INTERVAL after the camcorder starts recording. To change the settings, stop the recording pressing the VTR START button or VTR button on the lens or setting the POWER switch to OFF.
•When the camcorder power is switched off during recording in Manual Interval Rec mode
•When you set the POWER switch to OFF, the camcorder will switch off by itself after the tape has run for a few seconds to record the picture data stored in the memory.
•If you remove the battery, unplug the DC cable, or cut the power to the AC adaptor while manual interval recording, the image currently being shot on the camcorder (maximum 5 seconds) will not be recorded. Do not change the battery while recording in Manual Interval Rec mode.
•When tape runs out during recording in Manual Interval Rec mode
Note that the picture data (maximum 5 seconds) at the instant the tape stopped is not recorded if the tape runs out and the camcorder stops.
Chapter 3 Recording and Playback