To release the time code synchronization

First disconnect the external time code, then set the F-RUN/SET/R-RUN

switch to R-RUN.

To change the power supply from the battery pack to an external power supply during time code synchronization

To maintain a continuous power supply, connect the external power supply to the DC IN connector before removing the battery pack. You may lose time code synchronization if you remove the battery pack first.

Camera synchronization during time code synchronization

4

During time code synchronization, the camera is genlocked to the reference video signal input from the GENLOCK IN connector. When the NTSC/PAL composite video signal is input as the reference video signal, the genlock H-phase cannot be adjusted. Also, subcarrier of the down-converted signal (composite video signal) of the camcorder cannot be synchronized with external equipment when an HKDW-702 (not supplied) is installed.

Chapter 4 Adjustments and Settings for Recording 4-45