not stop immediately when you press the VTR START button. After the VTR START button is pressed, all tape operation buttons (EJECT, REW, F FWD, PLAY, and STOP) stop functioning until the Loop Rec time has elapsed. During this time, if you press the VTR START button or VTR button on the lens, the recording starts again as if there were no pause in recording
• The time the tape stops after the VTR START button is pressed equals 3 the Loop Rec time set. However, if you start recording within the set
Loop Rec time immediately after selecting the Loop Rec mode, changing the Loop Rec time or performing playback or recording review, the picture data for the duration of the Loop Rec time will not be stored in memory. Thus, the time the tape stops after the VTR START button is pressed becomes shorter than the Loop Rec time.
•The time code stops advancing while time data is being set (when the
Turning off the camera
•When the power is turned off during recording, the camera will switch off by itself after the tape has run for a few seconds.
•If you remove the battery, pull out the DC cable, or cut power to the AC adaptor during recording, recording of picture data ends the instant the tape is stopped. The recorded picture data is interrupted before the recording stop point. For this reason, make sure you do not change the battery while recording.
When the tape runs out during recording
Please note that picture data at the instant the tape stopped is not recorded if the tape runs out and the camcorder stops. The recorded picture data is interrupted before the recording stop point.
Chapter 3 Recording and Playback