5-3 Mounting the Lens
Follow the procedure below to mount the lens.
For information about using the lens, refer to the lens manual.
Lens mount securing rubber
5
Mounting the lens
1 Push the lens locking lever up and remove the lens mount cap from the lens mount.
2 Align the center slot in the lens mount with the center pin on the lens, and insert the lens into the mount.
3 Holding the lens in place, push the lens locking lever down to mount the lens.
4
5
Note
If the lens is not firmly locked, it may come off while the camcorder is being used. This could cause a serious accident. Make sure the lens is firmly locked. It is recommended that the lens mount securing rubber be put on the
Connect the lens cable to the LENS connector.
Secure the lens cable with the cable clamps.