3 LIGHT connector (2-pin, female)

 

Connect the cable of the Anton Bauer Ultralight System attached to the

 

light shoe. The system operates with lights powered by 12 V, with a

2

maximum power consumption of 50 W.

 

 

4 Lens mount (special bayonet mount) Use this for mounting the lens.

5 Lens locking lever

After inserting the lens in the lens mount, rotate the lens mount ring with this lever to lock the lens in position.

6 Lens mount cap

Remove this cap by pushing up on the lens locking lever. For protection from dust, always insert this cap when no lens is mounted.

7 LENS connector (12-pin)

Fit the lens cable to this connector. Contact your Sony representative for more information about the lens you are using.

8 Tripod mount

When using the unit on a tripod, attach the supplied tripod adaptor.

9 Shoulder pad

You can move the shoulder pad forwards or backwards by loosening the two screws. Do this to ensure the best balance when shooting with the camcorder on your shoulder.

Note

Do not remove screws instead of loosening them. If you have removed them, be sure to use the screws you removed, or screws of the same length (8 mm). If you fasten the shoulder pad using longer screws, they may damage parts inside the unit.

2-4Chapter 2 Locations and Functions of Parts and Controls