If the automatic white balance adjustment cannot be made
If the white balance adjustment cannot be completed normally, an error message will appear for about 3 seconds on the viewfinder screen (in display mode 2 or 3).
Possible messages are listed below.
|
| White balance adjustment error messages | ||
4 | ||||
| Error message | Meaning | ||
| WHITE : NG | The white video level is too low. Either make open | ||
|
| |||
|
| LOW LEVEL | the lens iris or increase the gain. | |
|
|
|
| |
|
| WHITE : NG | The color temperature is too high. Select a suitable | |
|
| COLOR TEMP HIGH | filter setting. | |
|
|
|
| |
|
| WHITE : NG | The color temperature is too low. Select a suitable | |
|
| COLOR TEMP LOW | filter setting. | |
|
|
|
| |
|
| WHITE : NG | Adjustment could not be completed within the | |
|
| TIME LIMIT | standard number of attempts. | |
|
|
|
| |
|
| WHITE : NG | The white area could not be checked. | |
|
| POOR WHITE AREA |
| |
|
|
|
| |
|
| WHITE : NG | The white video level is too high. Either narrow the | |
|
| LEVEL TOO HIGH | lens iris opening or change the ND filter. | |
|
|
|
| |
If any of the above error messages is displayed, retry the white balance adjustment. If the error message occurs again, an internal check is necessary.
For information about this internal check, refer to “Maintenance Manual”.