G-3000H User’s Guide

 

Figure 110 Menu 3.5 Wireless LAN Setup

 

 

 

 

Menu 3.5 - Wireless LAN Setup

 

Operating Mode= Bridge / Repeater

Edit MAC Address Filter= N/A

 

Edit Roaming Configuration= N/A

 

Hide Name (SSID)= N/A

Edit SSID Profile= N/A

 

Select SSID Profile= N/A

 

Channel ID= CH06 2437MHz

Edit Bridge Link Configuration= No

 

RTS Threshold= 2432

Preamble= Long

 

Frag. Threshold= 2432

802.11 Mode= Mixed

 

 

Max. Frame Burst= 650

Breathing LED= Yes

Block Intra-BSS Traffic= No

Output Power= <11b>17dBm/<11g>13dBm

Edit Layer-2 Isolation= N/A

Press ENTER to Confirm or ESC to Cancel:

Press Space Bar to Toggle.

The following table describes the fields in this menu.

Table 64 Menu 3.5 Wireless LAN Setup

FIELD

DESCRIPTION

 

 

Operating Mode

Press [SPACE BAR] and select Access Point, Bridge / Repeater, AP + Bridge or

 

MESSID.

 

This field is not available on all models.

 

 

Name (SSID)

The SSID (Service Set IDentity) identifies the AP to which the wireless stations associate.

 

Wireless stations associating to the AP must have the same SSID. Enter a descriptive

 

name of up to 32 printable 7-bit ASCII characters.

 

This field is only available when you select Access Point or AP + Bridge in the Operating

 

Mode field.

Hide Name (SSID)

Press [SPACE BAR] and select Yes to hide the SSID in the outgoing data frame so an

 

intruder cannot obtain the SSID through scanning.

Channel ID

Press [SPACE BAR] to select a channel. This allows you to set the operating frequency/

 

channel depending on your particular region.

RTS Threshold

Setting this attribute to zero turns on the RTS/CTS handshake. Enter a value between 800

 

and 2432.

Frag. Threshold

This is the maximum data fragment size that can be sent. Enter a value between 256 and

 

2432.

Edit MAC Address Filter

Press [SPACE BAR] to select Yes and press [ENTER] to display Menu 3.5.1 - WLAN

 

MAC Address Filter.

Edit Bridge Link

Use [SPACE BAR] to choose Yes and press [ENTER] to go to Menu 3.5.4 - Bridge Link

Configuration

Configuration.

Edit Roaming

Use [SPACE BAR] to choose Yes and press [ENTER] to go to Menu 3.5.2 - Roaming

Configuration

Configuration. This field is not available when you select Bridge / Repeater in the

 

Operating Mode field.

Chapter 17 LAN Setup

181